HOSES & AIR TREATMENT
CEILING PENETRATION FLANGE
Suitable for Suspended & Plaster ceilings.
Compression fitting lubricant spray.
NOTE: Do not use in spray painting application. See installation instructions.
ANTI VIBRATION PADS
AVR-S Anti-vibration General Purpose.
Isolation Pads for noise and vibration isolation. Spring mounts also available for specific applications.
MAXAIR SAFETY SIGNS
REFER TO TECHNICAL DEPARTMENT FOR COMPLETE SIGN RANGE
MAXAIR MULTIBORE POLYURETHANE
We only stock good quality PVC hoses, there will always be some cheaper hoses, but usually the PVC resin in them has a lot of worthless fillers in it or less reinforcing. Cheaper brands get stiffer and more brittle or fail by puncture or blow out. Experience has proved often that you can’t afford to buy the cheapest.
HIGH QUALITY PVC 250PSI WORKING PRESSURE, GOOD FLEXIBILITY AND KINK RESISTANCE
|AHYB6||Blue||6mm x 20m|
|AHYB8||Blue||8mm x 20m|
|AHYB10||Blue/Yellow||10mm x 20m, 100m|
|AHYB12||Blue/Yellow||12mm x 20m, 100m|
|AHYB20||Blue/Yellow||20mm x 20m|
BREATHING AIR SAFETY YELLOW
|BAH8||Yellow||8mm x 20m|
|BAH10||Yellow||10mm x 20m|
|AHY20||Yellow||20mm x 20m|
|AHY25||Yellow||25mm x 20m|
MAXAIR HOSE REELS
Hose reels are a simple workplace solution resulting in increased safety, improved efficiency and reduced accidents. Hose reels increase efficiency by helping to create a neat and tidy workplace. Hazards will decrease, which saves lost work hours due to injury and enables workers to get on with their job without having to find hoses, untangle hoses, coil and replace them.
FEATURE & BENEFITS
- Up to a 5 year warranty
- Highest quality ‘finished edge’ Spring steel strip
- Full flow full DR brass swivels and fluid paths
- Positive crimp hose fittings
- Tough, impact corrosion resistant and UV stabilised Polypropylene with Anti-static and flame retardants
- Unique ratchet tensioning system
- Heavy Duty wall mounting swivel system
- Food grade approved materials
- Detailed operation and service manual
GENERAL PURPOSE AIR OR WATER REELS
|MODEL||HOSE ID||HOSE LENGTH||MAX PSI||INLET FITTING||OUTLET FITTING||TEMP RANGE||WEIGHT|
|AW815||8mm||15m||240||3/8″ BSP F||3/8″ BSP F||-5/+65°C||11kg|
|AW820||8mm||20m||240||3/8″ BSP F||3/8″ BSP F||-5/+65°C||12kg|
|AW1015||10mm||15m||240||3/8″ BSP F||3/8″ BSP F||-5/+65°C||12kg|
|AW1020||10mm||20m||240||3/8″ BSP F||3/8″ BSP F||-5/+65°C||12kg|
|AW1215||12mm||15m||240||1/2″ BSP F||1/2″ BSP F||-5/+65°C||12kg|
|AW1218||12mm||20m||240||1/2″ BSP F||1/2″ BSP F||-5/+65°C||12kg|
Other reels available. Hot Wash, Electrical, Chemical, Oxy, Lubrications, Safety Barrier.
MAXAIR AIR TREATMENT
Compressed Air contains impurities such as dust and dirt (approximately 80% of these pass through the compressor inlet filter), and water vapour is also present as humidity, concentrated eight times as compared to the air we breath.
These impurities combine with traces of compressor oil to form an abrasive sludge which wears and corrodes bearings and seals in pneumatic tools and equipment. For this reason it is imperative to include
Air Treatment in your system which will protect your equipment. We can assess and advise you as to your particular requirements, please refer to technical department.
PRE-FILTERS, FINAL-FILTERS AND ACTIVATED CARBON FILTERS (BREATHING AIR)
We offer a large range of multi-layer coalescing filters to remove particles, oil & water mists.
Dryers cool compressed air to approx 3˚ dew point and remove condensate before entering pipe system. They must be sized correctly and be rated for Australian conditions.
Twin tower Dessicant Dryers remove condensate and give very low dew-points (water vapour). They are mostly used in specialist or medical applications.
Single tower Dessicant Dryers are suitable for general applications. Please refer to Technical Department.
FILTER REGULATOR & REGULATOR
Full range of Regulators, Filter Regulators and FRL’s available. Auto drain models also available.
FILTER REGULATOR LUBRICATOR
Full range of Automatic Condensate Drains available including bottom entry type.
Full Range of air receivers available. Vertical & Horizontal mounts.
MAXAIR BLOW GUNS AND PIPE LABELS
Standard Blow Guns, Long Nozzle, Safety Tip, Rubber Tip, Flat Nozzle, Blow / Vacuum Venturi Effect, Reduced Pressure Safety Styles.
Premium self-adhesive pipe marker labels to AS1345-1995.